Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Decatur, AL

Extension Spring Replacement in Decatur, AL

Side-mounted extension springs replaced in matched pairs, with safety cables installed. Typical cost $150-$350.

Our extension spring replacement service in Decatur, AL comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for extension spring replacement

  • A stretched, sagging or snapped spring along one of the horizontal tracks
  • The door lifts unevenly or sits crooked
  • A missing or broken safety cable through the spring
  • Pulleys squealing or wobbling

Why this happens

  • Metal fatigue from years of stretching
  • Rust and worn pulleys
  • Mismatched springs from an earlier repair

Before the technician arrives

  • Make sure each extension spring has a safety cable running through it. That cable keeps a snapped spring from flying across the garage.
  • Look at the pulleys and cables for fraying.
  • Don't try to stretch or re-hook an extension spring under tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle extension spring replacement

  1. Open the door fully and secure it so spring tension is released
  2. Replace both springs as a matched pair, color-coded for door weight
  3. Replace worn pulleys and lift cables if needed
  4. Install or replace the safety containment cables
  5. Balance the door and test it through several cycles

How much does extension spring replacement cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Decatur, AL and nearby towns

Humidity in Alabama puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our extension spring replacement service covers Decatur (ZIP codes 35601, 35602, 35603, 35609 and 35699) and nearby towns including Trinity (6 mi), Priceville (7.5 mi), Hartselle (11.6 mi) and Athens (13.6 mi). Call (833) 435-8883 to book a visit in Decatur.

Extension Spring Replacement: frequently asked questions

How much does extension spring replacement cost in Decatur, AL?

Extension Spring Replacement typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do extension spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is extension spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Alabama or Decatur requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Decatur, AL

Martin Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

LiftMaster Garage Door Opener Repair

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $125-$350

Marantec Garage Door Sensor Repair

Marantec is a German manufacturer of residential and commercial door openers.

Typical $100-$250

Holmes Garage Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Broken Garage Door Spring Repair

Fast replacement of broken torsion or extension springs, sized to your door's weight.

Typical $200-$450

Richards-Wilcox Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Linear Opener Circuit Board Replacement

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $175-$400

Linear Remote & Keypad Programming

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $50-$150

Genie Smart Garage Door Opener Setup

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$900

Sommer Remote & Keypad Programming

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $50-$150

Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Overhead Door Garage Door Installation

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $1,200-$4,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Decatur, AL now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote